Quantities test All This data module contains the examples from Chap 3.9.6.2.1.10 of the S1000D Issue 4.2 specification, and is used for testing the display of quantities. Example 1: Quantity group and is a simple quantity with value and unit of measure: The windshield assembly weighs approximately 40 and requires two persons ... ]]> The display of this markup can be as follows: "The windshield assembly weighs approximately 40 and requires two persons ..." Example 2: Quantity where value and tolerance have the same unit of measure: If hole tolerance of 0.700 0.010 0.000 has been exceeded ... ]]> The display of this markup can be as follows: "If hole tolerance of 0.7000.0100.000 has been exceeded ..." Example 3: Quantity with minimum/maximum values: Tighten fasteners 18.0 22.0 using torque wrench ... ]]> The display of this markup can be as follows: "Tighten fasteners 18.022.0 using torque wrench ..." Example 4: Quantity with type, value, tolerance, and unit of measure: Holding nut, torque bolt to 20 2 .]]> The display of this markup can be as follows: "Holding nut, torque bolt to 202." Example 5: Quantity with multiple value groups and value and tolerance with different units: Chamfer both sides of rib 0.153 0.005 x 45 30 .]]> The display of this markup can be as follows: "Chamfer both sides of rib 0.1530.005 x 4530 ." Example 6: Quantity with tolerance only: Make sure that spacing is within 0.030 on each side ... ]]> The display of this markup can be as follows: "Make sure that spacing is within 0.030 on each side ..."